Urethane Slot Car Tyres x 4 Wasp 24A Scalextric 1980's and 1990's F1 Front and Rear

Made from Hi definition 3D printed blanks for perfect roundness. Rear face of tyre is smooth as its sliced off after moulding. Moulded in Smooth-on Vitaflex 40 Poly Urethane resin to give a good grip on both wood and plastic. Urethane tyres don't require any oiling or special treatments. They will run on the track alongside rubber and will not strip the grip as silicone can. WASP - 24a is 2 front tyres and 2 rear tyres ( a full car set) Tyres will fit all F1, F3 and single seaters produced bu Scalextric between 1980 to 2000 models starting from C142 through to C2460 Dimensions Rear (A diameter) 20.5mm (off the wheel) x (B width) 14mm x (C profile) 4.2mm x (D groove width) 2.5mm Front (A diameter) 20mm (off the wheel) x (B width) 9.5mm x (C profile) 4mm x (D groove width) 2.5mm see image for info Safety - Please note these tyres are intended for slot racing purposes only, they are not a toy and should not be used by children under 12 years. They could be a choking hazard if swallowed Fitting guide The table below shows the cars the tyres are known to fit. These are confirmed as I own the cars, Will fit other models, please refer to the image to gauge the size your car needs. Note the outer diameter is very flexible and will stretch a lot to fit a wheel. I usually design the tyres slightly small so they have a nice secure seat on the wheel and don't require gluing.

Please take a look at our models, kits and figures

Thank you for looking